How To Reset Maintenance Light On Toyota Corolla 2010 Ideas. Then turn the power off. At the “reset data” prompt, select “yes“.
Just follow these simple steps: Reset maintenance required light on 2009 corolla. When a service technician changes the engine oil in the corolla, he resets the maintenance light so it will not turn on again until the mileage threshold is reached.
Table of Contents
Before You Decide To Reset The Maintenance Required Light In Your Toyota Corolla, It’s Important To Understand Why It Came On.
Press the “engine start stop” 2 times to enable the accessory mode; At the “reset data” prompt, select “yes“. 4.push and hold the odometer trip pushbutton.
If You Would Like Me To Do Another.
Press the odo/trip button to display trip a. Many toyota corolla models are equipped with a maintenance reminder light that turns on at regular mileage intervals to remind the driver to get the engine oil changed. Unlike the “check engine” light, the toyota maintenance required light in the gauge cluster—which reads “maint reqd”—means that it has been 5,000 miles since the last reset.
Image For Reference Only May Different From Your Model.
Toyota matrix maintenance required reset. When a service technician changes the engine oil in the corolla, he resets the maintenance light so it will not turn on again until the mileage threshold is reached. Then hold odo/trip reset button, then press the “ engine start stop button ” twice or turn ignition on only, don’t release the odo/trip button, until the resetting oil maintenance data or “ 000000 ” is displayed.
2.While Pressing The Trip Meter Reset Button, P.138 Turn The Engine Start/ Stop Switch Or Engine Switch On.
Reset maintenance required light on 2009 corolla. Then turn the power off. 5.while holding the trip pushbutton depressed, turn the ignition switch to the.
2.Depress The Odometer Pushbutton Until It Indicates “Trip A” Mileage.
This video shows how to reset the oil maintenance light on a 2011 toyota corolla. This video shows u how to reset the maint req'd light after doing an oil change on a 2010 toyota corolla. U need to put it on trip a (with the key off) once u get in on trip a, push and hold the button down,while holding button down turn key on, you will see lines pop up on the odometer, (where the miles are displayed) they will go out one by one, once it.